E.M.COAT-90-B E.M.COAT-90-B | Paints and Coatings

Home

E.M.COAT-90-B

EMULSIFIED BITUMEN PROTECTIVE COATING
DESCRIPTION
E.M.COAT-90-B is a water based bitumen emulsion of mineral petroleum sprits. Conformed to
be tested by related standards of ASTM and EN based standards, E.M.COAT-90-B is
essentially designed to positively protect buried concrete structure from any water vapor or harsh chemical ingress through it.
Applied and well cured E.M.COAT-90-B will left a high resistance tensile and elongation film over the substrate of being used.

Method

SURFACE PREPARATION
The substrate should be clean and sound, free of dust, loose particles, grease, oil, primers from
previous membrane systems. Spalled concrete should be repaired by cutting out to sound
concrete and patching with E.M.SUPER REPAIR .Cracks, holes and honeycombs must be repaired prior to application.

APPLICATION
The application using brush or roller requires laying the material onto the surface, avoiding
brushing out, to achieve the required film thickness per coat. It is recommended that two coats
should be applied at a rate of 1-2.7 m2 per litre of product depending on the degree of protection
required. In hot climate, it should be applied when temperature is below 40°C.

Properties

ADVANTAGES

Resists chemical attack by chloride and sulfate ions present in the ground water.
Versatile.
Economical.
Easy to apply.
Cold applied.
Contains no solvent, no health hazard.

Application

FIELD OF APPLICATION

General waterproofing and damp proofing for concrete and masonry.
Protection to a variety of buried structures such as concrete foundations and retaining walls.
Provides a vapor barrier for cold storage rooms, etc.

Physical and Chemical Properties

Density	Approx. 1.10 g/cm3.
Drying tack free	Approx. 40 minutes at 23°C.
Recoat	4 hours.
Fully dried	3-7 days depending on ENV. Condition.
Application temp	10-40 °C (Recommended).
Coverage	1 to 2.7 m2/litre.

Considerations

PACKAGING
18 kg plastic pail.

STORAGE & SHELFLIFE
The shelf life is 12 months if unopened, stored free from frost, moisture and direct sunlight.

Protection and Safty

HEALTH & SAFETY
E.M.COAT-90-B contains bituminous material. Therefore, as with all chemical products, care
should be taken during use and storage to avoid contact with eyes, mouth, skin and foodstuffs.
When applying gloves & goggles should be worn. Wash off splashes to skin with water.
If in eyes wash out with plenty of clean water and seek medical attention. Reseal containers after use.
Use in well ventilated areas and avoid inhalation. E.M.COAT-90-B is non-flammable.
MSDS is available at ABADGARAN website.

Other Products

E.M.P10

ABADUR 210

ABATEXTURE

ELASTOCOLOR

ELASTOPAINT

ELASTOCOAT

E.M.COAT-90

ABABITUMER

ELASTOPOOL

ELASTOPRIME