Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address info@abadgarangroup.com

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.
phone
instagram
telegram
aparat

ABADUR 210

TWO COMPONENTS COAL TAR EPOXY CURED WITH POLYAMIDE

DESCRIPTION

A two component coal tar epoxy coating which displays excellent corrosion and chemical resistance for tank lining, immersion and non-immersion service in crude oil, salt solutions and fresh or sea water with just a single coat.

ABADUR-210 is industrial lining and coating for use varying from cold to hot climates on marine structures, pilling, ballast tanks, crude oil cargo, ships bottoms, burned pipes, oil production and refining plants, sewage treatment plants.

ABADUR-210 is suitable for use over both steel and concrete. It normally does not require a primer or any additional topcoats but also can be applied over inorganic zinc silicate primer to serve as a tie coat between primer and topcoat.

APPLICATION

  • Material is supplied in two containers as a unit. Always mix a complete unit in the proportion supplied. Once the unit has been mixed it must be used within the working Pot life specified.
  • Agitate part A with a power agitator.
  • Combined entire contents of curing agent (part B) with base (Part A) and mix thoroughly with power agitator
  • To prevent moisture condensation during application, surface temperature must be at least 3 ºC above the dew point.
  • In hot climate, material temperature should be 20 to 25 ºC prior to mixing; otherwise pot life becomes very short.
  • For satisfactory cure, air and surface temperature must be above 10 ºC
  • Paint shall not be applied when wind speed is in excess of 7 m/s.

ADVANTAGES

  • Cathodic protection system.
  • High adhesion to surface.
  • High mechanical strength.
  • Abrasion resistant.

FIELD OF APPLICATION

  • Refineries.
  • Marine structures.
  • Offshore platforms.
  • Wastewater treatment plants.

Please refer to the Technical Data Sheet.

PACKAGING

  • 29 kg set.
  • Part A (Base): 25 kg.
  • Part B (Hardener): 4 kg.

 

STORAGE & SHELFLIFE

The shelf life is 12 months if unopened, stored free from frost, moisture and direct sunlight.

HEALTH & SAFETY

This product is Flammable. Keep away from heat and open flame .Keep container closed .Use with adequate ventilation. Avoid prolonged and repeated contact with skin. If used in confined areas, observe the following precautions to prevent hazards of fire or explosion or damage to the health:

1-Circulate adequate fresh air continuously during application and drying.

2-Use fresh air masks and explosion proof equipment.

3- Prohibit all flames, sparks, welding and smoking.

MSDS is available at ABADGARAN website.

WE DEVELOP CHEMISTRY